2.6 Status Bar
The status bar in at the top of the display and will give you some important information about the ATime at any time.
.svg)
GPS: synchronized 
GPS signal lost
GPS: not synchronized 
Synchronized manually
Synchronized using WTN
Not synchronized
Ethernet
Section titled “Ethernet”
Connected
Error- No icon: disabled
High signal
Low signal
Disconnected
Error- No icon: disabled
Bluetooth
Section titled “Bluetooth”
Connected
Searching
Error- No icon: disabled
Printer
Section titled “Printer”
Disabled
Error
Missing paper- No icon: enabled
Display
Section titled “Display”
Touch disabled- No icon: touch enabled
Timing channels
Section titled “Timing channels”Usually C0 is start, C1 is stop and C3/C4 are intermediates.
Ready channels
Triggered channels
Locked channels
Short-circuited channels
Battery
Section titled “Battery”
Charging
Not charging
Low battery
-edit.svg)
If you wipe down from here the menu will open
Examples
Section titled “Examples”Example 1
Section titled “Example 1”
- Time synchronized using GPS
- Wifi and bluetooth connected. Printer is enabled.
- All the four channels are ready
- Battery is full and connected to an external power supply
Example 2
Section titled “Example 2”.svg)
- Time is not synchronized
- Wifi and bluetooth are disabled. Printer is enabled.
- Touch is disabled
- C0 just received a trigger
- C1 and C4 are locked
- C3 is short-circuited
- Battery is 13% and is low
Example 3
Section titled “Example 3”.svg)
- Time is synchronized manually
- Wifi and bluetooth are disabled. Printer is out of paper
- C0, C3, C4 are ready
- C1 just received a trigger
- Battery is 62%